Inspect should be able to inspect one or more containers depending
on the user input. Therefore, inspect output should be in array
format so the consumer could potentially iterate it. This PR allows
users to specify one more or containers|images|or a mix for
inspection. The output, as stated, is therefore in array form. This
holds true even for a singular image.
In the case that the user enters an invalid container|image "name", we
handle that gracefully. Podman will output json for the valid names
until it reaches the invalid one. For example:
In this case, podman will out the json for alpine and then print an
error about 123 being invalid. It will not continute onto busybox.
This behavior imatates docker.
This addresses issue #360
Signed-off-by: baude <bbaude@redhat.com>
Closes: #371
Approved by: baude
Changing these fields caused the output of podman inspect to more
closely match docker inspect.
Signed-off-by: Daniel J Walsh <dwalsh@redhat.com>
Closes: #306
Approved by: mheon
sudo is not required when running as root, and # indicates
that you are already root. $ indicates you are not root.
Signed-off-by: Daniel J Walsh <dwalsh@redhat.com>
Made a change to make sure that the output paths of podman inspect
matches that of docker inspect. For example to get the stop signal
you should be able to do podman inspect ctr --format {{.Config.StopSignal}}
and the same thing in docker will give the same results.
Signed-off-by: umohnani8 <umohnani@redhat.com>
Closes: #292
Approved by: rhatdan
It is desirable to have a shortcut for the most
recently created container. We can now use "**latest"
to represent the most recent container instead of its
container ID or name. For example:
Signed-off-by: baude <bbaude@redhat.com>
Closes: #179
Approved by: baude
